LG Electronics OSW100 TV Mount User Manual


 
4
BEFORE INSTALLATION
* Do not use the product for purposes other than mounting a display on the wall.
* When installing/using the wall mount, be cautious of product damage and avoid accidents.
* If you have not fully read and understood the installation manual, do not install the product and contact
the dealer to have a specialized installer install the product for you.
* This product is designed to be mounted to walls that use standard intervals between the studs.
* Install the screw to attach the wall mount so that it can be assembled at the center from both ends of
the studs. Use of a stud finder, a separate device, is recommended.
* When installing the wall mount on a concrete wall or on any other wall capable of holding the strength
specified in the manual, you can detach the standard gap bracket for stud wall mounting and then
follow the instructions for attaching the wall mount to make the installation easier.
* Install the product only on a vertical wall.
The manufacturer is not responsible for issue from installing the product on an angled wall or on the
ceiling.
* Check that the accessories provided with the product are all included before installing. LG Electronics
is not liable for any damage or loss of accessories after the package has been opened.
* Keep the included accessories out of reach of babies or children as it can cause safety issues
including suffocation from swallowing the parts.
* Make sure screws are tight against the wall, but do not overtighten.
Applying excessive force to screws may damage to the wall, affect the product performance, or cause
the product to become damaged.
* Be careful not to install a TV that exceeds the weight restrictions of the wall mount.
* Be careful with the tools used during installation to prevent accidents or damage.
- Tools you will need - Phillips head "+" driver (manual or motorized) Ø4 mm drill bit for wood or steel /
Level / Stud finder / Drill. You may also need an 8 mm socket wrench or an Ø 8 mm drill bit for
concrete.
INSTALLATION METHOD
- The actual product may differ from the picture.
1
How to Attach the Spacers to the Hanger
Hanger
Spacer
Spacer
Attach the spacers
to the hanger in the
direction of the
dotted lines as
shown in the
illustration.
2
- If the screws are not fully tightened when you fix the top and the bottom wall mount, check the length
of the screws and tighten them again.
- Always install the display with 2 or more people.
- Work procedure
1. Remove the two VESA screws from
upper back of TV when in an upright
position.
2. Use the screws for attaching the
hanger to tighten the hanger as
shown.
- Tighten the screws for attaching the
hanger until they are securely
attached to the TV set.
- Use the + driver (manual or
motorized) when tightening the
screw.
3. Remove the four stand screws
tightened at the bottom of the TV set
to detach the stand.
- Place the TV on a table with the
screen facing up. Make sure that you
place it on a flat surface covered with
a soft cloth or cushion to protect TV
set from scratches.
* CAUTION
- When detaching the stand, make
sure to hold it firmly while removing
the screws. Otherwise, it may fall.
- The four stand screws removed will be
used to attach the bottom wall mounts.
4. Use the 4 stand screws to tighten the
bottom wall mount as shown.
- Tighten the stand screws and bottom
wall mount until they are securely
attached to the TV set.
- Use the + driver (manual or
motorized) when tightening the
screw.