Filter
Top Products
7
ENGLISH
Remove the wall mount fixing screws.
A A
→ Rotate the two screws next to A
counterclockwise to remove the screws
and the mounting bracket for wooden
walls from the top wall mount.
→ Place the top wall mount onto the area
of the wall where you want to install it,
and then mark the fixing point for the
fixing screws and remove the top wall
mount.
→ Attach the top wall mount to the wall by
referring to the illustration below.
→ Check if the wall mount is level by
using a leveler.
Wall mount screw
A
A
→ Fix one wall mount fixing screw into the
top left hole next to A and another
screw into the top right hole next to A
as shown in the illustration.
→ At this time, use a + driver (Manual or
motorized) or 8 mm wrench to tighten
the screw so that the wall, wall bracket
and screw are completely pressed
against one another.
→ After attaching the screws, put down
the top of the top wall mount.
When mounting to wooden studs
406 mm
drywall
drywall
wood stud
76 mm
a. Locate and mark the centers of the wall studs using a stud finder.
b. After aligning the wall bracket on the wall where the center of the wood stud is marked, mark the
location of the screws and then remove the wall bracket.
c. Use a level to make sure your screw marks are level.
d. Use the 4 mm drill bit for wood to drill holes with the depth of 76 mm or above where the wall mount
screw location is marked on the wall.
e. Clean the drilled hole.
f. Tighten the wall mount screws for the wall bracket on the drilled hole.
→ At this time, tighten the screw so that the wall, wall bracket and the wall mount screw are pressed
against one another.
(Drywall can be damaged when tightened with excessive force, please be careful.)
→ When tightening the screw use the + driver (manual or motorized) or 8 mm wrench.
- Check the material of the wall and the thickness of the finishing.
- Use the anchors for wall material of concrete, light concrete, strong natural stone, soft natural stone
masonry brick and hallow block that do not crack.
- Do not mount the device on the walls made from plasterboard or medium density fiberboard (MDF).
In this case, the anchor and screws must be inserted into the concrete behind the finish surface. If
there is no concrete on the other side, then you must first install a separate hanger to securely install
the anchors and screws.
- When installing the product on wall material not designated, install the product so that each location
can withstand the pull out load of 70 kgf (686 N) and shear load of 100 kgf (980 N) or above.
- Use the Ø8 mm drill bit for concrete and hammer (impact) drill.
a. Use a drill bit Ø8 mm to drill a hole for the anchor location within a depth of 80 mm - 100 mm
b. Clean the drilled hole.
c. Insert the sealed anchor to the hole. (When inserting the anchor, use a hammer.)
d. Set the wall mount on the wall by aligning to the location of the hole. and, set the angle adjusting part
to face upward.
e. Align the wall mount bolt to the hole and tighten it. Then, fasten the bolts at torque
of 45 kgf/cm - 60 kgf/cm.
→ For easier installation, it is recommended that you remove the two wall mount attaching screws
attached to the mounting bracket for wooden walls.
→ To detach the mounting bracket for wooden walls, first lift the top of the top wall mount at 90 degrees.