Filter
Top Products
- 66
Operating Loewe equipment
Using the remote control for the TV mode of the TV set
Press the TV button, the display above it will light for
approx. 5 seconds.
Using the remote control for additional equipment
Press the REC, DVD or AUDIO button, the display above
it will light for approx. 5 seconds.
As long as a button is pressed, the display of the selected operating mode
lights up (TV – REC – DVD – AUDIO). This allows you to check which
operating mode the remote control is set to every time you press a button.
Setting the remote control for other Loewe devices
Press required device button along with the STOP button at the same time,
until the associated LED display flashes twice. Then enter the two-digit
device code from the list.
Device Code Factory setting
Loewe ViewVision 8106 H 10
Loewe Viewvision, Centros 21x2 12
Loewe ViewVision DR
+
DVB-T 13 REC
Loewe Auro 2216 PS/8116 DT 14
Loewe BlutechVision 15
Loewe Soundprojector 17
Loewe TV - digital radio 19 AUDIO
Loewe Mediacenter 20
Loewe BlutechVision Interactive 21 DVD
HDMI CEC mode 22
Loewe Soundprojector 2 23
Loewe AudioVision 24
Resetting to factory setting 99
The associated LED display flashes twice.
➠ The codes shown here only apply for direct operation of the accessory
device. For operation of the accessory device via the TV set, e.g. with
concealed installation, see page 51.
Operating additional equipment
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
32
18
19
20
21
22
23
24
25
26
27
28
29
30
31
33
17
Downloaded From TV-Manual.com Manuals