Filter
Top Products
69 -
Troubleshooting
Problem Possible cause Remedy
All menus are displayed in the wrong language. The menu language was set incorrectly. Set the menu language:
Press the INFO button in TV mode (Index).
Mark the first key word and call it with OK.
Then select the language and confirm it with
OK.
In the TV menu, Connections cannot be called
(displayed in grey).
A timer recording is in progress. Wait until the timer recording ends or delete
the timer recording (page 58).
The control functions of the Loewe Recorder
and the Timer are not working or are not
working properly
a) The Digital Link function is not activated or
not possible in the recorder.
b) EURO-AV cable is not connected.
c) Recorder is not logged in.
a) Activate Digital Link in the recorder (see
operating instructions of the recorder).
b) Connect EURO-AV cable (page 49).
c) Register recorder (page 46).
General problems when connecting external
devices via an AV input.
a) The device is not logged in to the connection
wizard or is connected differently than is shown
in the connection diagram.
b) The AV standard is set incorrectly.
c) The signal type is set incorrectly.
a) In the connection wizard (TV menu
Connections New devices/modifications)
compare the connection diagram with the
actual installation and connect as illustrated
(page 46).
b) Set the correct standard (page 18).
c) Set the correct signal type (page 47).
If for AV standard or AV signal is set to
"Automatic" then this can cause errors to
be detected with signals that do not
comply with standards. In this case
standard and signal must be set according
to the information in the operating manual
of the external device.
The connection of a decoder does not
function or does not function properly.
a) The signal is not decoded because the correct
decoder stations have not been selected in
the connection wizard.
b) In decoder mode the sound is missing
because the wrong decoder sound has been
assigned in the connection wizard.
a) Follow the instructions in the connection
wizard (
TV menu Connections New
devices/modifications) and select the
appropriate decoder transmitter (page 46).
b) Follow the instructions in the connection
wizard and select the right audio source
(Decoder, TV oder Autom.) (page 46), see
also decoder instructions.
Errors occurred when running a CA module. Switch the TV set off. Remove the CA-module
from the TV set. Wait a few seconds. Reinsert
the CA-module. Switch the TV set on again.
Downloaded From TV-Manual.com Manuals