Filter
Top Products
11 -
Installing the TV set
First prepare the chosen installation solution for your TV set. See the
installation instructions of the wallmount supplied. See Accessories (page
69) for other installation possibilities.
Preparing the remote control unit
Inserting or replacing batteries
Press the embossed arrow and push down the
battery compartment cover.
Insert two alkaline manganese LR 03 (AAA) batteries;
ensure that the + and – poles are correctly positioned!
Slide the cover up from below.
Adjusting the remote control for operating the TV set
Press the TV button.
See page 62 to learn about operating other Loewe
devices.
Initial installation
Connecting the TV set
Connecting to the mains
➠ Note the position of the mains connection in
Individual Compose 40 / 46 / 52.
Remove the cover for the connections.
Connect the TV set to a 220-240V outlet:
First plug the small plug of the mains cable into the
mains connection on the rear of the TV, then plug the
large plug into a mains power outlet.
Connecting the antenna
Analogue / DVB-C / DVB-T antenna:
Plug the antenna plug of antenna system, cable system,
or room antenna into the ANT2 socket.
The connecting cable between ANT-TV – ANT OUT is
plugged at the factory.
Satellite antenna:
Connect an antenna plug, e.g. from the antenna change-
over switch or from the twin-LNC of the satellite system
to the sockets ANT-SAT resp. ANT-SAT2.
When connecting only one SAT antenna cable, connect
it to ANT-SAT.
Replace the cover over the connections.
Connecting speakers
How to configure and connect TV speakers, speaker
systems or active speakers is described from page 47.
Receiving coded stations
When using a CA module and a Smart-Card to receive
coded stations, please observe the handling of the CA
module (see page 35).
Connections on the back of the set (see also page 5 and 6).
TV
R
ANT
SAT
ANT2
ANT
SAT2
220-240V~
50/60Hz
Individual Compose: 40 / 46/52
AAA LR03
AAA LR03