Filter
Top Products
34
Logitech®
This hardware device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions: 1) this device may not cause harmful interference, and 2) this device must
accept any interference received, including interference that may cause undesired operation. This
equipment has been tested and found to comply with the limits for a Class B digital device, pursuant
to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses, and can radiate
radio frequency energy and, if not installed or used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does cause harmful interference to radio
or television reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures: 1) reorient
or relocate the receiving antenna; 2) increase the separation between the equipment and the
receiver; 3) connect the equipment to an outlet on a circuit different from that to which the receiver
is connected; 4) consult the dealer or an experienced radio/TV technician for help. Any changes or
modifications not expressly approved by the party responsible for compliance could void the user’s
authority to operate the equipment. Where shielded interface cables have been provided with the
product or specified additional components or accessories elsewhere defined to be used with the
installation of the product, they must be used in order to ensure compliance with FCC regulations.
This equipment complies with FCC radiation exposure limits
set forth for an uncontrolled environment. End users must follow the specific operating instructions
for satisfying RF exposure compliance. This transmitter must not be co-located or operating in
conjunction with any other antenna or transmitter.
This digital device does not exceed the Class B limits for radio noise
emissions from digital apparatus specified in the interference-causing equipment standard entitled
“Digital Apparatus, ” ICES-003 of the Department of Communications. This device complies with
RSS-210 of Industry and Science Canada. Operation is subject to the following two conditions: 1)
this device may not cause interference, and 2) this device must accept any interference, including
interference that may cause undesired operation of the device.
La Déclaration suivante d’Industrie Canada s’applique à tous les produits Logitech en général:
Déclaration d’Industrie Canada: Cet appareil numérique est conforme aux limitations concernant
l’émission d’interférences radio par des appareils numériques de catégorie B, telles que stipulées
dans le cadre de la norme Appareils numériques NMB-003 édictée par Industrie Canada.
Cet équipement a été déclaré conforme à la norme CNR-210 édictée par Industrie Canada. Son
fonctionnement est soumis aux conditions suivantes: 1) l’équipement concerné ne doit pas causer
d’interférences, et 2) il doit accepter toute interférence reçue, y compris les interférences risquant
d’engendrer un fonctionnement indésirable.
Your Logitech® 2.4 GHz cordless
product uses channel- and frequency-hopping technology to avoid interference with other cordless
devices. Your product has been extensively tested with other 2.4 GHz cordless devices and RF-
(radio frequency) emitting devices (cordless phones, cordless headsets, wireless networks, cordless
cameras, A/V senders/receivers, etc.). Most likely you will not experience any RF interference
between your Logitech® cordless product and the devices listed above. In some cases, however,
it is possible that interference may occur. This interference could result in erratic behavior or a
complete loss of signal in the other cordless devices. If you notice this behavior (or static, clicking, or
humming) in the other cordless devices, there are two actions you can take to reduce or eliminate
the interference. 1. Increase the distance between your Logitech® cordless product (including the
receiver) and the other cordless devices/receivers. 2. When using your Logitech® cordless product,
turn off the other cordless devices that are in close proximity.