Filter
Top Products
33
Network Setup
Network Setup
IP Setup
1. IP: Configure the IP address for the DVR unit. Navigate
using the
K and L buttons. Press the < and > buttons to
move within the IP address, and press + and - to change
the numbers.
2. SUBNET MASK: Configure the Subnet Mask for the DVR
unit. Navigate using the
K and L buttons. Press the < and
> buttons to move within the Subnet Mask, and press +
and - to change the numbers.
3. GATEWAY: Configure the Gateway for the DVR unit. Navigate using the K and L buttons. Press
the < and > buttons to move within the Gateway, and press + and - to change the numbers.
4. TCP PORT: Configure the TCP Port for the DVR unit. Navigate using the K and L buttons.
Press the < and > buttons to move within the TCP Port, and press + and - to change the numbers.
5. HTTP PORT: Configure the HTTP Port for the DVR unit. Navigate using the K and L buttons.
Press the < and > buttons to move within the HTTP Port, and press + and - to change the numbers.
6. DHCP: Sets DHCP to Enable or Disable. Navigate using the K and L buttons, and press + and
- to change the setting to Enable or Disable. When DHCP is enabled, the DVR will automatically
obtain an IP address (when connected to the Network). If set to disabled, an IP address will
need to be manually assigned to the DVR unit.
7. MAC: Displays the MAC Address for the DVR Unit. This information cannot be changed.
IP Setup
IP: 192.168.000.111
Subnet Mask: 255.255.255.0
Gateway: 192.168.000.001
TCP Port: 2505
HTTP Port: 0050
DHCP: Disable
MAC: 01:23:45:67:89:AB