Filter
Top Products
52
REGULATORY
FEDERAL COMMUNICATIONS COMMISSION (FCC) NOTICE (U.S. ONLY)
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful inter ference to radio communications. However, there
is no guarantee that interference will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception, which c an be determined by
turning the equipment off and on, the user is encouraged to try to correct t he interference by
oneormoreofthefollowingmeasures:
Use only RF shielded cable with ferrite core when connecting this monitor to a computer device.
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
To prevent damage which may result in fire or shock hazard, do not expose this appliance to rain or excessive moisture.
THIS CLASS B DIGITAL APPA RATUS MEETS ALL REQUIREMENTS OF THE CANADIAN
INTERFERENCE-CAUSING EQUI PME NT REGULATIONS.
• RF shield cable with ferrite core can be obtain from multiple retail outlets or Philips Factory Service Center.
• The RF shield cable with ferrite core part number is 3138 198 71441.
• If your RF shield cable without ferrite core,you can obtain the ferrite core from Philips Factory Service
Center, installation as following.
1. Opentheferritecore.
2. Locatethevideoconnectorthatgoestothecomputerand
plugsintotheunit.Placetheferritecoreasclosetothe
videoconnectoraspossible,asshowninthe figurebelow.
3. Locktheferritecore.
4. Placetwocabletiewraponeithersideoftheferritecore
topreventitfromslidingdownthecable,asshowninthe
figurebelow.
5. Drawthetiewrapstightandcutofftheexcessleads.
Cabletie
Ferrite Core
Installation
Toensurecomplianceofthisunittothe
ClassBlimitsoftheFCCRules,Part15,
SubpartB.
Thiskitmustbeutilizedwhen
“non-ferrited”videocablesareused
withthisunit.Thisinstructionsheet
givesthedetailsforproperinstallation.
AdditionalFCCinformationmaybe
foundintheradiofrequencyinterference
statementlocatedintheuser’smanual.
Interfacecable
Videoconnector
FerriteCore
Changes or modifications not expressly approved by the party r esponsible for compliance
could void the user’s authority to operate the equipment.