Filter
Top Products
USING THE REMOTE TO CONTROL CABLE BOX FUNCTIONS
30
USING THE REMOTE TO CONTROL CABLE BOX FUNCTIONS
Operating the pre-coded function for your Cable Box
This Genius Remote is designed to operate different types of cable boxes.
You must first program the Genius Remote to match the remote system in
your cable box. (Refer to Table 2 on page 25).
1. Set the MULTI-PAGE select switch to "CATV".
2. Set the USE/LEARN mode select switch to "USE."
3. Turn ON your cable box.
4. Aim the Genius Remote control at the front of your cable box.
5. While holding down the SELECT button, press the button that matches
our cable box as shown on page 25. Continue to hold down both buttons.
The channels of the cable box will begin changing when the correct button
is pressed. When this occurs, the Genius Remote Control is programmed
for your cable box. If the cable box channels do not change after 5
seconds, try a different Genius Remote button.
6. Release both buttons when the cable box starts to change channels.
The Genius Remote will now control your cable box.
Click here to see the CLU-850GR in the CATV position.
NOTES:
1. If your cable box cannot be operated after performing the above
procedures, this means that your cable box codes have not been precoded
into the GENIUS REMOTE. Please store your cable box codes in memory by
using the USER mode. (Refer to page 26.)
2. The GENIUS REMOTE CONTROL will remember the codes you have
programmed in until the batteries are removed from the GENIUS REMOTE
CONTROL. After replacing the batteries repeat the entire programming
procedure stated above.
PRECODED FOR CABLE BOX
These buttons always transmit the chosen precoded CATV codes.
SELECT BUTTON
This is for setting up the cable box's Pre-code.
EXCLUSIVE TV BUTTONS
These buttons are for operating the TV.