Filter
Top Products
USING THE GENIUS REMOTE TO LEARN ADDITIONAL FUNCTIONS
33
USING THE GENIUS REMOTE TO LEARN ADDITIONAL FUNCTIONS
The Genius Remote is equipped with a learning function which allows it to
learn additional infrared control codes. This remote will not only control the
television, a VCR, and a cable box, but also other electronic equipment
which uses an infrared remote transmitter, by learning the transmitter's
codes.
Only infrared remote control codes can be stored in memory.
Before starting the memory operation
Since the infrared signals sent from the remote transmitter may be
reflected by a wall, door, etc., even if the transmitter is not pointed directly
at the device, it may operate. When storing the remote control codes of
another device, turn OFF the power of the device (VCR, Cable Converter,
etc.)
If you do not do this, the device may work unexpectedly. The power could
be turned ON, an important tape could be erased, the volume could
increase too much, etc..
Click to see CLU-850GR in the USER position
LEARNABLE BUTTONS
These buttons can "learn" the codes of other remote control transmitters
when the MULTI-PAGE select switch is set to the "USER" mode.
MULTI-PAGE keys (A through L): No codes have been factory stored to
these keys.
Learning buttons other than MULTI-PAGE buttons: the codes for the TV
have been stored in memory. However, the remote control codes of other
equipment (cable converter, audio equipment, etc.) can be stored using
the learning function as shown on page 27, 28.
EXCLUSIVE BUTTONS
These buttons are for operating the TV.
Storing Operation
Set the remote transmitter as shown below.
Put the remote transmitter which contains the codes to be stored and the
GENIUS REMOTE transmitter to face each other. (Distance should be 2 -
4 inches.)
Set the LEARN/USE mode select switch located on the back of the
Genius Remote to the LEARN position.