Filter
Top Products
32
3,4,
5
1
2
PICTURE
SOUND
FEATURES
INSTALL
TIMER
AutoLock
CLOSED CAP
FORMAT
TIMER
AutoLock
CLOSED CAP
FORMAT
TIME
START TIME
STOP TIME
CHANNEL
ACTIVATE
FEATURES
TIMER
FEATURES
TIME 8:06 PM
START TIME
STOP TIME
CHANNEL
ACTIVATE
8
TIMER
FEATURES
TIME
START TIME _ _:_ _
STOP TIME
CHANNEL
ACTIVATE
TIMER
FEATURES
TIME
START TIME
STOP TIME _ _:_ _
CHANNEL
ACTIVATE
TIMER
FEATURES
TIME
START TIME 8:00 AM
STOP TIME
CHANNEL
ACTIVATE
7
6
9
2
TIMER
FEATURES
TIME
START TIME
STOP TIME 9:30 AM
CHANNEL
ACTIVATE
SETTING THE TIMER’S START TIME AND STOP TIME
Y
ou can set the Timer to switch to a selected
channel at a specific time while you are
watching another channel, or when the TV is in
standby mode. (Standby mode is when the TV is
plugged into the wall outlet but turned off.) If
you want, you can also set the TV to turn off at
some time after the TV switches channels.
Follow the steps below to set the Timer’s
START TIME and STOP TIME.
1
Press the MENU button on the
remote control to show the onscreen
menu.
2
Press the CURSOR BUTTON
DOWN twice to highlight FEA-
TURES.
3
Press the CURSOR BUTTON
RIGHT to enter the FEATURES sub-
menu.
4
Press the CURSOR BUTTON
RIGHT again. Then press the CUR-
SOR RING DOWN once to highlight
the START TIME control.
5
Press the CURSOR BUTTON
RIGHT to highlight the time indica-
tor area.
6
Press the NUMBER buttons to enter
the correct time. If you make a mis-
take entering the time, use the CUR-
SOR BUTTON LEFT or RIGHT to
move among the time input slots to
make corrections.
NOTE: You can also use the CUR-
SOR BUTTON UP or DOWN to
cycle through digits to input the time.
7
Press the CURSOR BUTTON UP or
DOWN to select AM or PM.
8
Press the CURSOR BUTTON LEFT
repeatedly until START TIME is high-
lighted. Then press the CURSOR BUT-
TONDOWN to highlight STOP TIME.
If you want the TV to switch off at some
time after the changing of channels, fol-
low steps 5–7 above to set the STOP
TIME.
9
Press the STATUS/EXIT button to exit
the menu.
See pages 33 and 34 for instructions on selecting
the Timer’s channel and activating the timer.
Using the Onscreen Submenus: Features