Filter
Top Products
12 First-Time Setup, Watching TV
The TV/DVD can memorize available TV channels. If you are
using a Cable Box or Satellite Receiver, you do not need to
set channels at the TV/DVD. Set the TV/DVD to the output
channel of the Cable Box or Satellite Receiver (channel 03 or
04) or AUX. Then select channels at the Cable Box or
Satellite Receiver. Details are on page eight.
These SETUP screens will appear the first time you turn on
the TV/DVD.
1
Press STANDBY-ON to turn on the TV/DVD.
2
Press ENTER repeatedly to select ENGLISH,
ESPAÑOL, or FRANÇAIS. The selected language
will appear inside the [ ].
This will be the language of the TV/DVD setup menus.
3
Press ▲ or ▼ to select AUTO PRESET. Then
press ENTER. The TV/DVD scans and memorizes
active channels.
When scanning is complete, the TV/DVD will go to
the lowest available channel automatically.
4
To watch TV, press the CH. ▲ or ▼ buttons to
select memorized channels. Memorized channels are
those that appear automatically when you flip through
channels. If a channel is skipped, you still can use the
Number buttons to select it. This is a non-memo-
rized channel; it may have weak reception in your
area.
Remember, if you are using a Cable Box/Satellite
Receiver, set the TV/DVD to channel 3 or 4 or AUX.
Change channels at the Cable Box/Satellite Receiver.
5
Press VOL. ▲ or ▼ to adjust the volume.
VOLUME 20
– SET UP –
LANGUAGE
[ENGLISH] ESP FRA
AUTO PRESET
B
– SET UP –
LANGUAGE
[ENGLISH] ESP FRA
AUTO PRESET
B
• If the power fails, you may need
to repeat this first-time setup.
• You may not see these menus
when you turn on the TV/DVD.
Set channels and the menu lan-
guage later. Details are on
pages 18-19.
• To select Cable TV channels high-
er than 99, press the +100/+10
button, then press the Number
buttons for the last two digits.
For example, to select channel
125, press +100/+10, 2, 5.
Precede single-digit channel num-
bers with a zero (for example,
01 ... 09).
• Pressing CH. ▲ or ▼ in DVD
mode will return the unit to TV
mode.
• If you turn off the unit in DVD
mode, when you turn it on again,
it will be in TV mode.
• To remove the SET UP menu,
press SETUP on the remote.
Helpful Hints
2-3
1
4
5
TD007.QX33 03.3.14 1:50 PM Page 12