Filter
Top Products
1-8-1 T1202NT
HOW TO INITIALIZE THE TV/DVD/VCR
To put the program back at the factory-default, initialize the TV/DVD/VCR as the following procedure.
< DVD Section >
1. Turn the power on and press [SELECT] button on
the remote control unit to put the TV/DVD/VCR
into DVD mode.
2. Press [1], [2], [3], [4], and [DISPLAY] buttons on
the remote control unit in that order.
Fig. a appears on the screen.
3. Press [CLEAR] button on the remote control unit.
Fig. b appears on the screen.
When “OK” appears on the screen, the factory
default will be set.
4. To exit this mode, press [CH. o / p] or [SELECT]
button to go to TV mode, or press [STANDBY-ON]
button to turn the power off.
< TV/VCR Section >
1. Use the service remote control unit.
2. Turn the power on. (Use main power on the TV
unit.)
3. Press [DISC MENU] button on the service remote
control unit to enter the Service mode. (Refer to
“How to enter the Service mode” on page 1-7-1.)
4. Press [VOL p] button on the service remote
control unit twice, and confirm that OSD indication
is “7F = FF.” If needed, set it to become “7F = FF”
by pressing [CH. o / p] buttons on the service
remote control unit.
5. Confirm that OSD indication on the four corners
on TV screen changes from on and off light
indication to red by pressing a [DISPLAY] button.
(It is necessary for one or two seconds.)
6. Turn the power off by pressing main power button
on the TV unit, and unplug the AC cord from the
AC outlet.
MODEL : *******
Version
: *.**
Region
: *
EXIT: SELECTEEPROM CLEAR : CLEAR
Fig. a
"
*******
" differ depending on the models.
MODEL : *******
Version
: *.**
Region
: *
EEPROM CLEAR : OK
EXIT: SELECTEEPROM CLEAR : CLEAR
"
*******
" differ depending on the models.
Fig. b