Filter
Top Products
2
VCR 1 will play your tape. Insert a prerecorded tape in VCR
1. If the tape does not have a record tab, playback begins. If this hap-
pens, press the STOP/EJECT button on VCR 1 once.
1
Make the connections shown above.
Rerecording (Tape Duplication) 33
3
VCR 2 will record your tape. Insert a blank tape in VCR 2.
Make sure the record tab is intact (details are on page five). Make sure
the VCR 2 power is on and VCR 2 is in VCR position. (The VCR/TV
light will appear. If it does not, press the VCR/TV button once.)
4
Turn on the TV and set it to channel 3 or 4, whichever
channel the CH3/CH4 switch on VCR 2 is set to.
5
Point the remote control at VCR 2. Press the Number but-
tons 0, 0, 1 or 0, 0, 2. (See Helpful Hints at right.)
6
Point the remote control at VCR 2. Use the SPEED button
to select SP or SLP.
7
Press the PLAY button on VCR 1 and the REC(ord)/OTR
button on VCR 2 at the same time.
8
To stop recording, press the STOP/EJECT button on VCR 2
once, then stop the tape on VCR 1.
• If you use the AUDIO and VIDEO IN
jacks on the back of VCR 2, press
Number buttons 0, 0, 1 at step 5.
LineIn Rear (L1) will appear on the
screen.
• If you use the AUDIO and VIDEO In
jacks on the front of VCR 2, press
Number buttons 0, 0, 2 at step 5.
LineIn Front (L2) will appear on the
screen.
• Unauthorized recording of copyright-
ed television programs, video tapes,
or other materials may infringe on
the rights of copyright owners and
violate copyright laws.
• If a program has copyright protection,
it may not record clearly.
• Audio and video cables are not sup-
plied.
• The illustration uses two VCRs just
like yours. Different VCRs may oper-
ate differently.
• When the VCR is in Line Input mode
(L1 or L2), the screen will be blue.
Helpful Hints
VCR 1
Playing VCR
VCR 2 - Recording VCR
1. Audio cables from AUDIO OUT Jacks
of VCR 1 to AUDIO IN Jacks of VCR 2
2. Video cable from VIDEO OUT Jack of
VCR 1 to VIDEO IN Jack of VCR 2
3. RF coaxial cable
from the OUT jack of
VCR 2 to the TV’s
ANTENNA IN Jack