Filter
Top Products
3Controls & Displays
15
English
Note
• HDMI ON is set when the unit is shipped from
the factory.
• Set HDMI under the DVD Setup Menu to use
HDMI functions (see pages 41, 42, 47).
• This remote control supports two remote control
codes: DVD1 and DVD2.
• When the unit is shipped from the factory, the
remote control is set to DVD1.
• To set the remote control to DVD2, hold down
both
7
(STOP) button and 2 number button on
the remote control for at least fi ve seconds. (If
the batteries in the remote control are replaced
while the remote control is set to DVD2, the
setting will revert to DVD1.)
• To set the remote control back to DVD1, hold
down both
7
(STOP) button and the 1 number
button on the remote control for at least fi ve
seconds.
• Also set the REMOT CODE on the FL menu to
the same setting as the remote control. (This
setting is set to DVD1 when the unit is shipped
from the factory.) (see page 34)