Filter
Top Products
DVD Setup Menu6
34
Using the FL menu
The FL menu has been designed to set
"REMOTE CODE".
It can be set during stand by mode.
If a Disc had been loaded, press Power
button on the Remote Control to stand by
mode.
Selecting the FL menu
1 Press SET UP for longer than 2 sec.
2 Stand by LED is disappeared and "REMOTE
CODE" is displayed in the FL display.
REMOTE_CODE
• If press ENTER, current status is displayed.
DVD_1
3 Use the cursor buttons (
5
/
∞
) to select the
type of REMOTE CODE you want to set as
follows.
4 Press ENTER you want to set.
• Press SET UP for longer than 2 sec to close the FL
menu and then go back to standby mode.
Note
• The DVD player support two remote control codes:
DVD 1 and DVD 2.
• Set the remote control code of the Remote Control
to the same setting. (page 15)
DVD 1
DVD 2