Filter
Top Products
User Guide
5
Charging the Remote Control
For charging the Remote Control you use the docking station.
1 Plug the power adapter into a wall outlet and connect it to the
docking station.
2 Place the Remote Control in the docking station.
Make sure you hold the Remote
Control at an angle of 30° to 45°
when you place the it in the
docking station.
Charging starts immediately. The green charging LED on the
front of the docking station indicates charging takes place.
When the Remote Control is fully charged, the LED goes off.
Note Normal charging time is 2 to 3 hours, depending on the
condition of the battery pack.
You can operate the Remote Control while it is being charged.
The battery pack does not have to be entirely empty before
recharging.
You can place the Remote Control in the docking station at any
time.
When the battery pack is running low, the Low Battery icon flashes
at the top of the screen. Recharge the Remote Control as soon as
possible to ensure perfect performance.
Note The RC9200/5200 retains all settings when the battery is
completely dead. You will only have to reset the clock.
Introduction