Filter
Top Products
15
MOTION
1. SEN (Sensitivity)
Sets the sensitivity of the Pixel-based Motion Detection feature from 1fo 70.
2. MD-NVM
Sets the number of targets in which Motion must occur in order to trigger an Alarm
(from 1-99 target areas).
Note: MD-NVM cannot be less than the number of targets set in the AREA.
3. RE
Sets the Reference image to which the current screen is compared (from 1-99).
For example, the value 64 would compare the current image to the 64
th
previous
screen image.
4. DET
The motion detection on each channel setup can be turned to
ON or OFF individually.
(MENU)
TIMER
CAMERA
RECORD
ALARM
DWELL
PIP
MOTION
DISPLAY
REMOTE
USER
SYSTEM
EVENT
(MOTION)
SEN MD-NVM RE DET
CAM1 70 03 64 ON AREA
CAM2 70 03 64 OFF AREA
CAM3 70 03 64 ON AREA
CAM4 70 03 64 ON AREA
MOTION RECORD : ON
DAY START END
DAILY 00 : 00 00 : 00
5. AREA
Press the ENTER button on this option to set the Pixel-based
Motion Detection Area for each channel. Green targets
represent the Motion Detection Area(Figure 1-2), and Purple
targets represent motion currently taking place (Figure 1-3).
To modify the Motion Detection Area, use the following controls:
+ : turns the selected target ON/OFF.
▲▼◄►: navigates between targets
- :turns all targets on the screen ON/OFF
Zoom: turns all targets in the selected row ON/OFF
6. MOTION RECORD
When the DET setting is “ON”, you can set up the MOTION RECORD function,
1. Select “ON” to set up the motion trigger record: It can automatically switch to Record Mode. The motion detection will
change the scanning sequence and shows on the monitor.
NOTE: The trigger recording time will depend on ALARM DURATION mode setting (Please refer to page.11 for ALARM DURATION) and it will
record from the last trigger time. For example, when the alarm duration setting is 1 min, the recording time is from 9:00:00 to 9:01:00. If the
motion detection trigged again at 9:00:40, the trigged recording time will from 9:00:00 to 9:00:40 and 9:00:40 to 9:01:40. The total
recording time is 00:01:40.
2. Select ”OFF”: The screen still shows and if it is in record mode, the motion detection will change the scanning
sequence.
For example : If the motion is detected on Camera #1, its recording & scanning sequence will be more frequently. The sequence
will be as 1st, 2nd, 1st, 3rd, 1st, … 4th. And channel 1 will show on the screen. If 2nd camera and 3rd camera
both motion detection are activated, they will be scanning as 2st, 3rd, 1st, 2nd, 3rd, 4th, 2nd, 3rd, 1st, 2nd, 3
rd
,
4th … and vice versa. And CH2 & CH3 will show for a period of time which is same as Alarm Duration time.