Maxtor 16Channel Stand Alone DVR DVR User Manual


 
26
CHAP. 5 Set Up
7) PASSWORD SETUP
-Use [UP] and [DOWN] button to move to option
and [LEFT] and [RIGHT] button to set user ID.
The password must be consist of 1 to 8 digit
number. Just use numbers button from 1 to 10
on the front panel of DVR unit.
-To change password, user must input current
password and then input new password.
And input again new password to confirm.
- Default value
ADMIN : ‘ ‘ (Blank)
MANAGER : ‘1’
USER 1 : ‘2”
:
:
USER 8 : ‘9’
Set user ID and password.
Change the user PASSWORD in the first operation is recommended.
In case you forgot PASSWORD, contact dealer of DVR to get instruction to enter into menu to
set new PASSWORD.
8) SYSTEM INFORMATION
DVR system information including firmware
version, hardware version, product ID, etc….
6) BUZZER SETUP
BUZZER SETUP
ALL
KEY BEEP
VIDEO LOSS
ALARM ACTIVE
MOTION DETECT
ON
ON
ON
ON
ON
SELECT : ▲▼, & [ENTER]
Set parameters for buzzer (On or Off).
Use direction button and [ENTER] button.
KEY BEEP : buzz when button is pressed.
VIDEO LOSS : buzz when video signal is lost.
ALARM ACTIVE : buzz when alarm is activated.
MOTION DETECT : buzz when motion is detected.
User can set all buzzers at On/Off at once
by set ALL at ON/OFF.
PASSWORD SETUP
USER I D
USER PW
NEW PW
CONFIRM
ADMIN
---------------------
---------------------
---------------------
[K1-K10] INPUT PASSWORD
[ENTER] CHANGE PASSWORD
TO EXIT, PRESS [MENU]
SYSTEM INFORMATION
S/W VERSION VER 1.0
H/W VERSION REV-B. / ES518
PRODUCT ID
01S-2039-001008-AR-01
MASTER-1
WDC WD2000JS-00NCB1
MASTER-2
WDC WD2000JS-00NCB1
CD-R
SAMSUNG CD-R/RW SW-256B
TO EXIT, PRESS [MENU]