Filter
Top Products
33
CHAP. 5 Set Up
4) SPOT MONITOR SETUP
(1) SWITCHING INTERVAL
Channel switching time (01 sec. ~ 99 sec.)
(2) ALARM POP-UP
When ALARM is detected, the image of channel
connected with Alarm sensor pops up.
Set ALARM detection pop-up (ON/OFF)
(3) MOTION POP-UP
Set MOTION detection pop-up (ON/OFF)
※
EVENT POP-UP DURATION
Set EVENT POP-UP DURATION
SPOT MONITOR SETUP
SPOT MONITOR SETUPSPOT MONITOR SETUP
SPOT MONITOR SETUP
SWITCH INTERVAL 03 SEC
ALARM POP UP ON
MOTION POP UP ON
EVENT POP UP DURATION 01 SEC
SELECT: ▲▼, CHANGE VALUE : + -
5) AUDIO SETUP
AUDIO SETUP
AUDIO SETUPAUDIO SETUP
AUDIO SETUP
CH REC PLAY
01 ON ON
02 ON ON
03 ON ON
04 ON ON
SELECT: ▲▼◀▶, & [ENTER]
Use direction button to move to channel and Press [ENTER] button to set (ON/ OFF).
1) REC
(1) ON : Record images with AUDIO
(2) OFF : Record images without AUDIO
2) PLAY
(1) ON : Recorded sound comes out during
playback
(2) OFF : Recorded images only play back
If events (MOTION or ALARM) happen on several channel at the same time, channel No. 1 has the
first priority to pop up. For example, if events happen on channel No. 1, channel No. 2, and channel
No. 4 at the same time, channel No. 1 pops up. If the motion disappears on channel No. 1, then channel
No. 2 pops up for the duration that you set. However, even though motion happens on channel No. 1
again within the duration, channel No. 2 still displays. If motion on channel No.1 keeps on going even after
the duration, channel No. 1 pops up again.