Filter
Top Products
-36-
Installation Of Plasma Panel T o The Wall (Optional)
1- To install the plasma panel on the wall, first of all, foot assembly should be removed.
(Figure 1). Unscrew the 4 screws (M5 x 12) that attach the foot assembly to the panel and
remove the foot assembly from the panel.
The plasma TV can be installed to the wall with or without speakers.
2- Install the wall hanger as in figure 2 to the wall with 4 anchors (M10 x 50) and 4 screws
(M7 x 60).
Decide the place on the wall w here the plasma panel would be placed. Level and mark
with a pencil the 4 m ounting points o n the wall hanger. Drill pilot holes for the plastic an-
chors and then fix the wall hanger with 4 screws (M7 x 60).
3- Raise the plasma panel and hang it to the holes on the wall han ger from the 2 hanging
screws at the rear of the plasma panel.
A sse mbling T he Speakers (Optional)
Turn the rear side of the plasma panel and place it on a solid surface such a s a table or a
desk. Put the speakers to the left and right sides of the panel. Place the speaker holders (2
on the left speaker and 2 on the right speaker) on the holes at the plasma panel and fix one
holder with 3 screws (M3 x 12) to the speaker and the panel. Connect the speaker cables to
the speakers and the Plasma Panel.
S
CREW
3X12
S
CREW M5X12
SCREW
3X12
SCREW
3X12
SCREW
3X12
HOLDER SPK AL P ART
HOLDER SPK AL P ART
PDP 4210
FI
GU
RE 1