Filter
Top Products
Setting the remote control
This is only necessary if your appliance does not respond to the RU760.
If that is the case, the RU760 does not recognize the brand and/or model of
your appliance and you need to program the remote control to do so.
The example below (TV) instructs you how to do this.
You can repeat the same steps for other appliances (DVD,VCR, etc.) which
you want to operate using the RU760.
Example of TV:
1 Turn on the TV manually or use the original remote control.
Tune in to channel 1.
2 Look up the brand of your TV in the code list at the back of this
manual. One or more four-figure codes are shown for each brand.
Note the first code.
Be careful! There are separate tables for TV,VCR, DVD, etc.
Make sure you use the codes from the correct table.
3 Select TV with the mode selector
(See ‘Testing the remote control’.)
4 Keep the LEARN key pressed for 5 seconds
until the green light around the Standby key
blinks twice and then remains lit.
5 Enter the code noted in step 2, using the digit keys.
– The green light will now blink twice.
If the light blinks once for an extended period, the code has not been
entered properly or the wrong code has been entered.
Start again from step 2.
6 Point the RU760 at the TV and check that it responds as it should.
– If the TV responds to all of the key commands, the RU760 is ready for
use. Do not forget to note your code.
• If the device does not respond at all, or not to all of the key
commands, start again from step 2 and try the next code from
the list.
VCRDVDSAT AMPCD
LEARN SELECT GUIDE
TITLE AUDIO CHAPTER SUBTITLE
DISC SYSTMENU
VCRDVDSAT AMPCD
LEARN SELECT GUIDE
TITLE AUDIO CHAPTER SUBTITLE
5
Instructions for use
English
RU760.qxd 04-06-2004 16:59 Pagina 5