Filter
Top Products
Automatically setting the remote control
If you cannot find the right code for your brand device, the remote control
can automatically search for the right code.
Example of TV:
1 Make sure the TV is switched on and select a channel using the original
remote control or the keys on the TV (for example channel 1).
The RU760 emits the ‘switch off TV’ signal for all models of TV that are
stored in the memory.
• If the device is a DVD-player or VCR, insert a disk or tape and start
playback.
2 Keep the LEARN key pressed for 5 seconds,
until the green light around the Standby key
blinks twice and then remains lit.
3 Press the Standby key of the RU760 briefly.
– The RU760 now starts emitting all known
‘TV off’ signals, one by one.
Each time a code is sent, the green light
around the Standby key lights up.
4 When your TV switches off (standby),
press the Standby key of the RU760
immediately to confirm.
– The RU760 has now found a code that
works on your TV.
5 Check if you can operate all functions on your TV with the RU760.
• If this is not the case, you can redo the automatic setting.The
RU760 will then search for a code that perhaps works better.
– After the RU760 has run through all the known codes, the search will
stop automatically and the green light will stop blinking.
– Automatic programming of a TV takes a maximum of 3 minutes.
VCRDVDSAT AMPCD
LEARN SELECT GUIDE
VCRDVDSAT AMPCD
LEARN SELECT GUIDE
VCRDVDSAT AMPCD
LEARN SELECT GUIDE
VCRDVDSAT AMPCD
LEARN SELECT GUIDE
TITLE AUDIO CHAPTER SUBTITLE
DISC SYST.MENU
6
Instructions for use
English
RU760.qxd 04-06-2004 16:59 Pagina 6