Mitsubishi Electronics 151 Flat Panel Television User Manual


 
Sound
Projector
19
Custom Sound Projector menu
Manual
Setup
Option
Microphone
/ on a tripod or
on the back-
rest of your
seat
TV
,/
6 ft.
minimum
+----------+
Microphone
Placement
Place the microphone at least 6 feet away from the
TV,
centered
in
front of the
TV.
Place the microphone on a flat, level surface such
as on a tripod
or
on the backrest
of
your seating.
Place the microphone where yours ears would be
when watching
TV.
Place it within 3 feet height from
the TV Speakers.
---------f
3ft
...
_+-..,
TV
Speakers-
!'!-
_t
Adjusting
Levels
1.
Adjust
Center
Level to the mid level.
2. Adjust individual beam one at a time so that each
one sounds about the same
as
the center level.
3. Check all sound levels by quickly switching
between them using
....
T.
4. Readjust individual levels
in
small increments.
Auto
Setup
Option
(153
or
249
series only)
1.
Plug the microphone into the left audio jack
of
the side panel
(INPUT
3).
If the microphone
is
not
plugged in, the TV will not allow the
Auto
setup.
2. Set
Mode
to
Auto. START
is
displayed in place of
Custom.
Highlight START and press
ENTER.
3. Quietly exit the room right away as your presence
will interfere with the calibration process.
4. Return to the room after the completion
of
setup.
5. Play some sample audio to check the sound quality.
Note: Do not perform manual adjustments after the
Auto setup. Auto calibration data will be erased.
6.
Store the microphone out
of
direct sunlight and
away from heat.
Sound to
be
equal
in
both ears.
Maximize the sound from the left.
Maximize the sound from the right.
Adjust as if the sound comes from
the left rear side, or same as that
for
Left
Angle.
Adjust
as
if the sound comes from
the right rear side or same as that
for
Right
Angle.
TV
Location
TVW.II
Othor
Wall
TV
to
Sofa
length
longth
./
Center 16
feet
14 rett 12
(eet
Custom
left
D
l Corner
Right
R Corner
(!)
Center
Angle
Left
Angle
Right
Angle
Right
Sur-
round
Angle
To
reset the beams, change the TV
Location
field.
At extreme beam angles, the image on screen may
not be accurate.
1.
From the
Initial>
SoundPro menu, enter the room
dimensions and layout information requested in the
screen. Press
....
T to specify the value.
2. Highlight
Custom
and press
ENTER
to fine tune the
direction and focus
of
the TV's sound output.
153
and
249
Series:
Select
Manual
option under
Mode
(refer to
the page
16),
for
Custom
button to
be
displayed.
The TV's bank
of
speakers can be adjusted to reflect
sound
off
the room walls to create a surround sound
effect. Setup can be performed manually for all models,
and
lor automatically depending on your TV models.
Adjusting
Angles
1. Position yourself
in
your usual viewing location.
2.
Press
....
T to seiect an audio beam.
3.
Press
<II
~
to redirect the audio beam or change
the sound level.
Downloaded From TV-Manual.com Manuals