Filter
Top Products
45
FX3S Series Programmable Controllers
User's Manual - Hardware Edition
1
Introduction
2
Features and
Part Names
3
Product
Introduction
4
Specifications
5
Version and
Peripheral
Devices
6
System
Configuration
7
Installation
8
Preparation and
Power Supply
Wiring
9
Input Wiring
10
High-Speed
Counters
5 Version Information and Peripheral Equipment Connectability
5.3 Use of (Built-in USB) Programming Port
5.3 Use of (Built-in USB) Programming Port
Make sure to set the contents described in this section when executing circuit monitor, device monitor,
program reading/writing, etc. in the FX
3S PLC using the (built-in USB) programming port and GX Works2.
5.3.1 Installation of USB driver
It is necessary to install the USB driver to execute USB communication using the (built-in USB) programming
port.
For the USB driver installation method and procedure, refer to the following manual.
Refer to the GX Works2 Version 1 Operating Manual (Common)
5.3.2 Setting in GX Works2
1. Double-click the Connection Destination view [Connection Destination] [(Connection
target data name)] in the Navigation window of GX Works2.
The [Transfer Setup Connection1] is displayed.
2. Double-click [Serial USB] of the PC side I/F to display [PC side I/F Serial Setting].
3. Select [USB].
4. Click the [OK] button to finish the setting.
Double-click it.
Select [USB]