Filter
Top Products
Chapter 3. NetCommand Setup and Editing 43
Edit NetCommand®: Adding an A/V Receiver
A/V Receiver Screen
Figure 8
If your A/V Receiver manufacturer was not listed, and you
selected “None” during the initial NetCommand setup,
you may add the A/V Receiver and have NetCommand
learn its remote control’s functions.
• If you are in the Finish screen for initial setup, select
Edit.
• If you have already finished initial setup, change the
audio source to TV speakers. Press the DEVICE
key to verify the current audio source. To change,
press the AUDIO key to acess the audio section
and change the source. Next open the Main menu,
select NetCommand, then press ENTER. The Edit
NetCommand screen will display.
Highlight Add and press ENTER. When the New Device
screen displays (see figure 16), press ADJUST or
until you see A/V Receiver as the device type. Highlight
Next and press ENTER to open the A/V Receiver screen
(figure 8).
IMPORTANT
To make changes to the A/V receiver setup,
first ensure that the current audio source is
the TV speakers.
Figure 8. A/V Receiver screen
Choose ONE of these options:
• Select a recognized manufacturer. The model
number optimized for NetCommand will display at
the bottom of the screen. If a number follows the
manufacturer’s name, (example: Mitsubishi 1), this
indicates additional models are optimized for that
manufacturer. For many device types, non-listed
models will operate in the same way as the listed
models and you can still use the pre-loaded setting.
After selecting Next>, the screens that follow are:
the Name Screen (Figure 12), Audio Output to AVR
screen (Figure 13), ending with the Finish screen
(Figure 14).
• Select “Other,” then highlight “Learn” and press
ENTER. This will allow you to have NetCommand
learn the remote control signals of this new device.
After selecting “Learn” and pressing ENTER, the
screens that follow are: the A/V receiver Inputs
screen (Figure 9), A/V Receiver Input Learn screen
(Figure 10), A/V Receiver Learn screen (Figure 11),
Name screen (Figure 12), Audio Output to AVR
screen (Figure 13), ending with the Finish screen
(Figure 14).
• Select “Other,” skip Learn and select Next>. This
will allow the device to appear and will allow
NetCommand to switch inputs to use this device.
However, NetCommand will not be able to control
this device. Later you may use the “Change” option
in the NetCommand menu to learn the remote control
signals.
After selecting Next>, the screens that follow are: the
A/V Receiver Input screen (Figure 9), Name screen
(Figure 12), Audio Output to AVR screen (Figure 13),
ending with the Finish screen (Figure 14).
A/V Receiver Inputs
Figure 9
Figure 9. A/V receiver Input screen
If you select “Other” as the manufacturer and then
“Learn,” you will see the A/V Receiver Input screen. After
selecting the number of inputs, this screen will not appear
again.