Filter
Top Products
40
repeat playback
You can playback a section of tape over and over using repeat
playback. The tape will play until the next index mark, rewind to
the previous index mark, and resume playing. If there is only one
index mark on the tape, then the VCR will play or rewind to that
mark and resume playback. If there is no index mark, the entire
cassette will repeat.
1 Press AUDIO/VIDEO on the remote control to display the
function menu. Press AUDIO/VIDEO until the Repeat play
function appears.
2 To start the playback, press ENTER.
When the VCR encounters the next mark or the end of the
tape, it will automatically rewind to the previous mark and begin
playback again.
The VCR will also search for a blank section of tape. If the
VCR encounters any blank sections longer than 4 seconds in
length, the repeat playback will begin.
3 Press STOP to cancel the repeat.
Search to blank
This feature allows you to find the end point of the recorded part of
the tape. The VCR will stop automatically at the beginning of the
blank section of a tape.
1 Press AUDIO/VIDEO on the remote control to display the
function menu. Press AUDIO/VIDEO until the Search to blank
function appears.
2 To start the search, press ENTER.
When the VCR encounters the blank section of a tape, it will
automatically stop.
IMPORTANT
This feature may not work if the blank section is within 5
minutes or less (15 minutes or less in EP mode) from your
current position.
VCR
Repeat play
Use ENTER to start
Advanced Features
VCR
Search to blank
Use ENTER to start