Filter
Top Products
27
If you cannot turn the cable box ON by pressing
POWER, try pressing CHANNEL or the number
buttons.
When set to TV, the PLAY, STOP, REW/REV, and
FF/FWD buttons will operate the VCR after the
VCR codes have been properly programmed into the
remote control.
Figure 3. Programming the remote to control your
VCR.
Figure 2. Programming the remote to control your
satellite receiver.
Figure 1. Programming the remote to control your
cable box.
Use of the Remote Control with Other A/V Products
Programming the Remote Control
to Use with Other Brands of Audio
and Video Products:
(Figures 1-3 this page, figures 4-5 following page)
1. Move the slide switch at the top of the remote to
the product you want to control.
2. Press and hold the POWER button on the remote
control.
3. Enter the first three digit code listed for your
equipment, and then release the POWER button
on the remote control.
4. Point the remote control to the equipment and
press the POWER button.
Note: If the equipment responds, the remote control is
properly programmed to operate the equipment. If
the equipment does not respond, repeat steps 2-4
with the next three digit code listed in step 3 for
your equipment.