Filter
Top Products
26
27
If you cannot turn the cable box ON by pressing
POWER, try pressing CHANNEL or the number
buttons.
When set to TV, the PLAY, STOP, REW/REV, and
FF/FWD buttons will operate the VCR after the
VCR codes have been properly programmed into the
remote control.
Figure 3. Programming the remote to control your
VCR.
POWER
Code to enter:
To reset to default code, enter 000
VCR brand
Mitsubishi
Hitachi
JVC
Phillips / Magnavox
Panasonic
RCA
Sony
Toshiba
001, 002
020, 043, 065
030, 054
043, 044, 051
041, 042, 043
020, 053, 065
048, 049, 050
021
If your
VCR
code is not
listed here,
please see
page 69
for a
complete
listing.
VCR Codes
1.
2.
3.
TV
AUDIO
CABLE/DBS/DTV
DVD
VCR
Figure 2. Programming the remote to control your
satellite receiver.
Figure 1. Programming the remote to control your
cable box.
Use of the Remote Control with Other A/V Products
Programming the Remote Control
to Use with Other Brands of Audio
and Video Products:
(Figures 1-3 this page, figures 4-5 following page)
1. Move the slide switch at the top of the remote to
the product you want to control.
2. Press and hold the POWER button on the remote
control.
3. Enter the first three digit code listed for your
equipment, and then release the POWER button
on the remote control.
4. Point the remote control to the equipment and
press the POWER button.
Note: If the equipment responds, the remote control is
properly programmed to operate the equipment. If
the equipment does not respond, repeat steps 2-4
with the next three digit code listed in step 3 for
your equipment.
For WS-48413, WS-55413 and WS-65413, the following information is not applicable if you are using NetCommand® IR.
POWER
Code to enter:
To reset to default code, enter 000
Cable box brand
General Instruments/
Jerrold
Motorola
Oak
Pioneer
Scientific Atlanta
Zenith
119, 120, 121, 122,123,
124
125, 126, 127
139, 137, 102
101, 116
112, 113
117, 100
If your
cable box
code is not
listed here,
please see
page 68
for a
complete
listing.
Cable Box Codes
1.
2.
3.
TV
AUDIO
CABLE/DBS/DTV
DVD
VCR
POWER
Code to enter:
To reset to default code, enter 000
Satellite brand
Mitsubishi DTV - DBS
DishNetwork
Hughes - DBS
Panasonic - DBS
RCA - DBS
Sony - DBS
Toshiba-DBS
006
175
173
174
176
177
170,
173, 189, 190, 191
If your
satellite
receiver
code is not
listed here,
please see
page 69
for a
complete
listing.
Satellite Receiver Codes
1.
3.
2.
TV
AUDIO
CABLE/DBS/DTV
DVD
VCR