Filter
Top Products
36
37
SETUP Menu: NetCommand® IR Setup, Language, IR
Device Setup Menus (WS-, WS-, WS-)
Figure 12. SETUP Menu, NetCommand® IR
MENU to return
Figure 13. NetCommand® IR Menu, Language
Figure 14. NetCommand® IR Device Setup Menu
NetCommand IR Setup Menu
(Figure 12)
For simple control with the Mitsubishi TV remote,
select the NetCommand IR SETUP from the
SETUP menu screen. There are basic steps to the
NetCommand IR Setup:
1. Select the devices that are connected to the TV
(Net Command IR Device Setup Menu)
2. Have the TV learn the device’s remote control keys
(NetCommand IR [Device] Learn menu)
3. Select or change the Input(s) the device(s)
is (are) connected to
(NetCommand IR Input Assignment Menu)
Language
(Figure 13)
On initial set up, before you can use the
NetCommand IR Menus, the language for the menu
screens needs to be selected. Your choices are English
or Spanish (Español).
NOTE: This Language screen only appears on initial TV
setup. To change the language later, select Language from
the SETUP Menu screen (page ).
NetCommand IR Menu
(Figure 14)
Select NetCommand IR to start the TV learning
process.
1. NetCommand IR Device Setup Menu
(Figure 14)
Using the Adjust buttons, select Yes for each device
(AV Receiver, Cable, DTV, etc...) you have connected
to the TV. After selecting Yes, press ENTER to have
the WS-, WS- or WS- go to the
Learn menu to start learning the device.
NOTE: If you connect a cable box with an RF
output other than channel , please see the Channel
Edit Menu on page .