Filter
Top Products
60
61
SQV (SuperQuickView™)
Using The Remote Control
Adding SQV channels using the remote control:
1. Press CH , or number buttons to select the
channel you want to add to the current SQV memory
bank.
2. Press and hold the SQV button for about 2 seconds.
When “SQV” and the memory bank number
appear under the channel number, the channel has
successfully been added.
Removing SQV channels using the remote control:
1. Press the SQV button and then the memory bank
number.
2. Press the SQV button repeatedly until you see the
desired channel.
3. While the channel number and SQV indicator (with
correct bank number) are still displayed on the
screen, press CANCEL. If the CANCEL button is
not pressed before the SQV indicator disappears
automatically, the channel will not be removed.
4. When the SQV indicator disappears, the channel
has successfully been removed only from that bank.
Other banks remain unchanged.
Viewing and changing SQV banks using the remote
control:
1. Press the SQV button.
2. To change memory banks, press a number button
within 5 seconds of pressing the SQV button.
3. Press the SQV button repeatedly to cycle through
the channels available in that bank.
SQV (SuperQuickView™)
Using The Menu Screen
Figure 17
SQV (SuperQuickView™) allows you to put together
lists of your favorite channels from Antenna-1 and
Antenna-2. You can store channels in any of the 9
different SQV memory banks. You can also store the
same channel in multiple memory banks. Once you
have added a channel to an SQV memory, “SQV” and
the memory bank number will appear under the tuned
channel number on the TV screen.
Adding SQV Channels
1. Select the channel by pressing ADJUST or
using the Channel text box or press CH or .
2. Highlight the bank (SQV1-SQV9).
3. Press ENTER to check mark the selected SQV
memory bank.
4. Repeat for additional channels or banks.
Removing SQV Channels
1. Highlight the box for the SQV bank number.
2. Press ENTER to remove the checkmark.
Antenna Menu, continued
Figure 17. Antenna Menu, SQV (SuperQuickView)