Mitsubishi Electronics WT-42315 Projection Television User Manual


 
14
15
Separate UHF and VHF Antennas
(Figure 1)
1. Connect the UHF and VHF antenna leads to the
UHF/VHF combiner.
2. Push the combiner onto ANT-A on the TV back
panel.
UHF/VHF combiners are not provided with the TV. They
are available at most electronic stores.
Note: This TV will only be able to provide an
analog signal through ANT-A on the
TV back panel.
See page 5 for Outdoor Antenna Grounding
information.





















Figure 1. Connecting separate UHF and VHF antennas.







 



Figure 2. Connecting twin lead antenna, coaxial lead
antenna, or wall outlet cable.
Twin Lead Antenna, Coaxial Lead
Antenna, or Wall Outlet Cable
(Figure 2)
For antenna with twin flat leads:
1.
Connect the 300 Ohm twin leads to the
transformer.
2. Push the 75 Ohm side of the transformer onto
ANT-A on the TV back panel.
300 Ohm to 75 Ohm matching transformers are not
provided with the TV. They are available at most
electronic stores.
For cable or antenna with coaxial lead:
3. Connect the incoming cable to ANT-A on the TV
back panel.
Note: This TV will only be able to provide an
analog signal through ANT-A on the TV back
panel.
See page 5 for Outdoor Antenna Grounding
information.
Connecting an Antenna or Wall Outlet Cable
Additional connection cables are not
provided with the TV. They should be
available at most electronic stores.
Note: The TV back panel and connections shown here are for reference only and may vary by model.
Connecting an Antenna or Wall Outlet Cable
Mitsubishi strongly recommends against
using antennas with twin flat leads. Twin flat
lead antenna wires are subject to interference
which may adversely affect the performance
of the TV. We recommend using coaxial
antenna cable.