Mitsubishi Electronics WT-42315 Projection Television User Manual


 
20
21
Connecting a DTV Receiver, continued
DTV Receiver with RGB Video
Connections
(Figure 13)
1.
Connect the outside antenna, cable, or satellite
to ANT or SATELLITE IN on the DTV receiver
(see your DTV receiver owner’s guide for
instructions and cable compatibility).
2.
If your DTV receiver has a built-in terrestrial
tuner, connect the incoming terrestrial antenna
to ANT on the DTV receiver. If your DTV receiver
does not have a built-in terrestrial tuner, this
TV will only be able to provide an analog signal
through Ant-A on the TV back panel.
3.
Connect the RGB cables from the DTV receiver
to the TV back panel as listed below (if your
DTV receiver uses BNC-type cables, use the
adaptors shown in Figure 11, page 19):
DTV Receiver
TV Back Panel
G (green) = Y/G
B (blue) = Pb/B
R (red) = Pr/R
4.
If the DTV receiver has outputs for H and V
sync, connect as listed below (DO NOT connect
if DTV receiver uses “Sync on Green”):
H (horizontal sync) = H
V (vertical sync) = V
5.
Connect the L (left) and R (right) audio cables
from the DTV receiver to DTV AUDIO on the TV
back panel.
6. To utilize the benefits of a digital A/V receiver,
connect your DTV receiver’s digital audio out
to a digital input on your digital A/V receiver.
You may need to setup the DTV (See Input
Assignment, page 35) to RGB.
Figure 13. Connecting the DTV receiver with RGB
video connections.












 
 








 




Note: The TV back panel and connections shown here are for reference only and may vary by model.
See Appendix, page 65, for component
video signal compatibility information.
For digital audio connections, see your
DTV and A/V receiver Owner’s Guides.
Connecting a DTV Receiver, continued