Filter
Top Products
Chapter 5. Operating Other Devices with the Remote Control 63
IMPORTANT
You may need to reprogram the remote
control after changing the batteries.
Programming the Remote Control
Method 1: Code Entry
1. Move the slide switch at the top of the remote to the
position for the product you want to control. Refer to
the table below. Only one of each device type can be
controlled in each slide-switch position.
Switch Position Affected Device
CABLE/SAT
Cable Box
DTV Receiver
Satellite Receiver
VCR
VCR
DVR
Laser Disc Player
DVD Player/Recorder
DVD
DVD Player/Recorder
DVR
Laser Disc Player
VCR
AUDIO
A/V Receiver
Audio Amplifier
CD Player*
2. Press and hold
POWER
on the remote control for several
seconds until the button blinks twice and goes off.
3. Release the
POWER
button.
4. Enter the first five-digit code listed for your equipment.
• The
POWER
button blinks twice when you start to
enter the code and then once for each additional
keypress.
• The
POWER
button blinks twice when you finish
entering a valid code.
• Move the slide switch to another position if you
need to start over or wish to exit programming
mode.
5. Point the remote control at the equipment and press
POWER
. If the product has no power on/off function,
press a different key, such as
(
PLAY
),
(
STOP
),
VOL
, or
MUTE.
• If the equipment responds, the remote control is
properly programmed to operate the equipment.
• If the equipment does not respond, repeat steps
2–4 with the next five-digit code listed for your
equipment.
6. Once you have found the correct code, write it in the
space below for future reference.
Switch Position
Device Type Code
CABLE/SAT
VCR
DVD
AUDIO
Method 2: Code Search
In this method of programming, you step through the
remote control’s internal code library to find the correct
code for your A/V product.
1. Move the slide switch at the top of the remote control
to the correct position for the product. See the table
under “Method 1.”
2. Press and hold
POWER
on the remote control for several
seconds until the button blinks twice and goes off.
3. Press keys
9 9 1
4. Press the number
1
,
2
, or
3
depending on the slide-
switch position and the table below.
Switch Position Number
CABLE/SAT
1
DVD, VCR
2
AUDIO
3
5. Press
CH
and
POWER
repeatedly until the product
responds by powering on or off. You can press
CH
to move backward through the code library if needed.
NOTE: If the product has no power on/off function, check
for a response using a different function. Press
(
PLAY
), (
STOP
),
VOL
, or
MUTE
and then re-
peatedly press
CH
/ to check for a response.
6. When the product responds, press
ENTER
to set the
code.
Code Verification
To determine the code programmed for any position of
the slide switch:
1. Move the slide switch to the position you wish to
verify.
2. Press and hold
POWER
on the remote control for several
seconds until the button blinks twice and goes off.
3. Press keys
9 9 0
4. Press
1
and count the blinks of the power button.
Write down the number of blinks as the first digit of
the code.
5. Repeat step 4 for the second, third, fourth, and fifth
digits of the code.