Filter
Top Products
64 Chapter 5. Operating Other Devices with the Remote Control
Audio Amplifiers
Brand Code
Acurus 30765
Adcom 31100, 30577
Altec Lansing 31742
Aragon 30765
Bel Canto Design 31583
Bose 30674
Carver 30892
Classe 31462, 31461
Curtis Mathes 30300
Durabrand 31561
Elan 30647
GE 30078
Harman/Kardon 30892
JVC 30331
Klipsch 30765
Left Coast 30892
Lenoxx 31561
Lexicon 31802
Logitech 31408
Marantz 30892
Mark Levinson 31483
McIntosh 30251
Mondial 30765
Optimus 30823, 30395, 30300
Philips 30892
Pioneer 30823, 30300, 30257, 30013
Polk Audio 30892
RCA 30823, 30300
Realistic 30395
Sharp 30226
Sony 30815
Soundesign 30078
Technics 30374, 30372
Toshiba 30353
Victor 30331
Wards 30078, 30013
Yamaha 30354
A/V Receivers
Brand Code
ADC 30531
Adcom 31617, 31616
Aiwa 31641, 31405, 31388, 31347,
31321, 31243, 30189, 30121
Akai 31255
Alco 31390
AMC 31077
Amplifier Technologies
31584
Anam 31609, 31074
Apex Digital 31774, 31430, 31257
Arcam 31189
Atlantic Technology 31487
Audiophase 31387
Audio Lock: Universal A/V Receiver Control
With Audio Lock active, the remote control operates
the volume and mute functions of the A/V receiver in all
positions of the slide switch. Activate Audio Lock if you
normally use an A/V receiver with your TV and other A/V
equipment.
1. Program the
AUDIO
position for your A/V receiver as
described earlier in this section.
2. Move the slide switch to the
AUDIO
position.
3. Press and hold
POWER
on the remote control for several
seconds until the button blinks twice and goes off.
4. Press keys
9 9 3 ENTER
The
POWER
button will blink twice to indicate Audio Lock
is active.
To Reset the Remote Control to Operate
Volume and Mute for the TV Speakers
1. Press and hold
POWER
for several seconds until the
button blinks twice and goes off.
2. Press keys
9 9 3 VOL
.
The
POWER
button will blink four times to indicate Audio
Lock has cleared.
Programming Codes
Resetting the Remote Control
If the slide switch is set to
TV
and the TV does not respond
properly, do the following to reset the remote control.
1. Press and hold
POWER
for several seconds until the
button blinks twice and goes off.
2. Release the
POWER
button.
3. Press keys
0 0 9 3 5
and the
POWER
button will blink
twice when you finish entering the code. While enter-
ing the code, pause for a moment between each key
press to ensure it is recognized.