Filter
Top Products
MODEL: WD-52527 / WD-52528 / WD-62527 / WD-62528
Page 27
3. Error Code Operational Check
Note: The TV must be in “Shut Down” and not have been switched Off, to perform the Error Code Opera-
tional Check. When the TV is switched Off, the code automatically resets to “12” No Error.
Pressing the front panel “DEVICE” and “MENU” buttons at the same time, and holding for 5 seconds,
activates the Error Code Mode. The LED flashes denoting a two digit Error Code, or indicating no problem
has occured since the last Initalization.
Note: The front panel buttons must be used, NOT those on the Remote Control.
• The number of flashes indicates the value of the MSD (tens digit) of the Error Code.
• The flashing then pauses for approximately 1/2 second.
• The LED then flashes indicating the value of the LSD (ones digit) of the Error Code.
• The Error Code is repeated a total of 5 times.
Example: If the Error Code is “32”, the LED will flash three times, pause, and then flash two times.
4. Error Codes
The Error Code designations indicating malfunction, or no malfunction, are listed below:
POWER
LED
STATUS
LED
LAMP
LED
Power
Status
Condition
Off Yellow Off
Low
Powe
r
Excess Temperature
Off or On Off Yellow
No
change
Usage time over 4000 Hrs.
Off Off
Blinks
Yellow
Low
Powe
r
Lamp Cover open
Off
Blinks
Yellow
Off " Filter Cover Open
Off Off Red Stb
y
Lam
p
did not turn On
Off
Blinks
Red
Off
Low
Powe
r
Fan Stopped
Off Red Off "
Circuit failure (short or DVI
connector unplugged)
Abnormal LED Indications
Error Codes "DEVICE" & "MENU"
Error Codes Description
12 No error detected
22 Recovery from Reset
32 Lamp cover is Open
33 Air Filter is open
34 Lamp abnormality
35 DM Fan failed
36 Exhaust or Lamp Ballast Fan failed
37 LCD Engine Fan failed
38 Lamp temperature abnormally high
39 LCD temperature abnormally high
41 Short is detected
42 Lamp Fan failed
44 DVI cable between Format and Engine disconnected
45 PBS Fan Failed
46 JC connector disconnected
47 DM Temperature too high
48 Engine power supply short detected
51 Speaker short detected
56 Shutter not connected