Filter
Top Products
15
ENG
PROGRAMMING THE REMOTE CONTROL
4 Place your original remote control to the HTR-5 head to head about 2-3 inches apart as
shown below.
HTR-5 Original Remote
5 Press either the device button or functional button, whichever you wish to teach in the
HTR–5. It is now ready to learn on the button you selected.
6 Press the button on your original remote control that you wish to teach the HTR-5. The
HTR-5 will “beep” indicating that it has received the signal and the LCD will show
“RETRY”. (Please enter the code signal within 20 seconds of programming).
7 Press the same button on the original remote control a second time to ensure correct
learning. The HTR-5 will beep a second time with “GOOD” flashed on the LCD screen,
indicating that it learned the code correctly. If it flashes “FAIL”, repeat from Step 5 until
it learns successfully.
8 Move on to the next button (or device) that you wish to teach by repeating from Step 5.
If you are teaching functional buttons, you can also move on to teach the buttons in
the next page by pressing the PAGE button.
9 Once you complete the teaching and wish to exit from the learning mode, press the
MAIN button to go back to the main page of the learning mode. Exit from the Main
page by pressing both the MAIN and PAGE buttons simultaneously.
10 You will now be in the setting mode once again. Move the cursor to 8. TO EXIT and
press down the joystick or simply press the MAIN button to exit to the main menu.