Filter
Top Products
17
ENG
PROGRAMMING THE REMOTE CONTROL
3 Press the MUTE button to move the cursor to the DEVICE BUTTON and keep the device
button you wish to erase all the learned commands down for five seconds until the LCD
shows ERASED. This will erase the function taught in the device button. If you continue
to press the device button for another five seconds, it will erase all the functions in the
device.
4 Once you complete the erasing and wish to exit from this mode, press the MAIN button
to go back to the main page of the learning mode. Exit from the Main page by pressing
the MAIN and PAGE buttons simultaneously.
5 You will be in the setting mode once again. Move the cursor to 8. TO EXIT and press
down the joystick or simply press the MAIN button to exit to the main menu.
TO ERASE ALL THE LEARNED COMMANDS IN ALL TWELVE DEVICES:
1 Go to the program setting mode by pressing both the MAIN and PAGE buttons
simultaneously for five seconds.
2 Move the cursor to 4. LEARNING with the joystick and then push the joystick down to
enter the learning mode.
3 Press both the POWER and STOP buttons simultaneously for five seconds in the learning
mode. The LCD will show ERASED after it has erased all the learned commands in the
remote control.
4 Once you complete the erasing and wish to exit from this mode, press both the MAIN
and PAGE buttons simultaneously.
5 You will be in the setting mode once again. Move the cursor to 8. TO EXIT and press
down the joystick or simply press the MAIN button to exit to the main menu.
NOTE
Preprogrammed code will be automatically restored when the learned function is erased.