Filter
Top Products
E-66
Signal Name Entry Method
Select [Source Edit] → [Name], then press the ENTER button to change to the
signal name entry display.
Here, the character entry and deletion methods will be described.
A maximum of 10 characters can be entered for the signal name.
Use the remote control number buttons and CTL button to enter the letters.
Example: Enter XGA
1) Enter X. (X is on the 8 button.)
Each press of the 8 button moves the selection through the sequence of
V→W→X→8 which repeats. Select X. To enter lower case and other charac-
ters, hold down the CTL button and select the characters.
2) Use the cursor ▲/▼ button to move the cursor to the next position.
Enter G and A using the same method as in Step 1).
* If a mistake is made, use the cursor ▲/▼ button to align the cursor with the
error, select the character, and correct it. To delete a character, press the CLEAR
button.
3) Press the ENTER button to set.
Name Input
Name Input
X
Name Input
X
Name Input
XGA
Name Input
XG
Correrspondence Table for Number Buttons and Letters
Number Buttons Press Directly Used with CTL
1 ABC1 a b
c !
2 DEF2 d e
f ” 3 GHI3
g h i #
4 JKL4 j k l
$
5 MNO5 m n o %
6 PQR6 p q
r &
7 STU7 s t
u ’
8 VWX8 v w x (
9 YZ?9 y z
/ )
0 * , . 0