Filter
Top Products
INTRODUCTION
Data Programming Procedure
NEAX2000 IVS
2
Office Data Programming Manual
ND-70931 (E), Issue 2.0 Page 3
DATA PROGRAMMING PROCEDURE
The following table shows the procedure and the outline of the office data programming for the
system.
The office data specified in this manual are entered to the system through the Customer
Administration Terminal (CAT) or Maintenance Administration Terminal (MAT).
STEP WORK REMARKS
1. Obtain the customer’s requirements, and
fill in the customer specifications sheets
in CHAPTER 1.
2. Allocate the LC, TRUNK and other
interface cards to the Port Assignment
Table in CHAPTER 1.
For mounting conditions of each card,
refer to the Installation Procedure
Manual.
For port assignment conditions of each
card, refer to the Command Manual
(CM10).
3. Fill in the data programming sheets in
CHAPTER 2 with the Customer
Specifications Sheet and Port
Assignment Table.
For the detailed information on each
Command, refer to the Command
Manual.
4. Check if data on all the programming
sheets are correct and consistent with
the customer specifications.
5. Specify the switch setting on the boards
with Switch Setting Table in the
Installation Procedure Manual.
For the function of each switch on the
cards, refer to the Installation Procedure
Manual.