Filter
Top Products
NEAX2000 IVS
2
Office Data Programming Manual
Page 6 ND-70931 (E), Issue 2.0
CHAPTER 1 CUSTOMIZING OFFICE DATA
How to Customize Office Data
HOW TO CUSTOMIZE OFFICE DATA
This section explains how to customize the office data.
The “Customer Specifications Sheet” section provides the data tables for the following items:
Numbering Plan
The Numbering Plan Data Table (Table 1-1) specifies the service feature access codes, trunk
access code, station numbers and other special access codes.
Service feature access codes and trunk access codes are given to each service feature and each
trunk route respectively with a maximum of four digits code. The station numbers are specified
by a maximum of eight digits.
For the numbering plan of the system, consider the following conditions:
(1) The same first digit code cannot be assigned to the other features within the programmed
Numbering Plan Group. (This condition is not applicable to the system providing the Single
Digit Timing Start Access.)
(2) The feature access codes should be three or four digits, because plural access codes for
each feature are required.
(3) There are eight types of station numbering (1 digit - 8 digits). Any combination of these
types is available in one system.
(4) The same station number cannot be assigned, even if the tenant service is applied.
Station Data
In Station Data Table (Table 1-2), the following data is required:
• Station Number
Up to 8 digits station numbers specified in the Numbering Plan Table are assigned. For the
D
term
station, specify the My Line number.