Filter
Top Products
NEAX2000 IVS
2
Office Data Programming Manual
Page 22 ND-70931 (E), Issue 2.0
CHAPTER 2 DATA PROGRAMMING SHEET
How to Read This Chapter
HOW TO READ THIS CHAPTER
The data programming sheets are given in numerical and alphabetical order of the command
code.
For programming procedure, see the CAT mode operation procedure below each data sheet.
In each sheet, the following symbols are used.
: Initial data which is automatically loaded into the memory, after system
initialization by setting position “B” on SW3 of the MP, followed by a reset.
: Commands that require a reset of the MP card after data setting.
: Commands that require a reset of the AP00 card after data setting.
: Commands that require a reset of the AP01 card after data setting.
: Commands that require a reset of the DCH card after data setting.
: Commands that require a reset of the DTI card after data setting.
: Commands that require a reset of the DBM card after data setting.
INITIAL
AP00 INITIAL
AP01 INITIAL
DCH INITIAL
DTI INITIAL
DBM INITIAL