Filter
Top Products
ENG-10
3. Attach the projector to the mount plate.
Line up the screw holes in the mount plate with the screw holes on the bottom of the projector and
securely tighten the four included M4×8 screws.
- Place a thick, soft cloth, etc., on the floor to protect the projector from scratches.
Note: “MAX.M4 x 8” is indicated on the four screw holes on the bottom of the projector. Note that
thisindicationisnotforthisproduct’sprojectoradapter.
- Mounting the projector using screws
other than the included ones could
damage the projector or result in it
falling and causing injury. Be sure to
use the included screws.
Mount plate
M4×8 screws
CAUTION
- Be careful not to touch the projector’s pro-
jection window when mounting the projector.
2. Attach the wall adapter to the wall’s structural material.
Use the included washers and spacers to attach the wall adapter with the M6 screws (or bolts).
- For the position for mounting the wall adapter onto the wall and the dimensions, see “Dimensions
of Parts” on page ENG-6 and “Projection Distance and Screen Size” on page ENG-7.
- Be sure to fasten the screws at the center of the mount holes, as they will serve as the refer-
ence points for the horizontal position.
- The wall adapter must be
installed in the proper up/
down direction. Mount it
in the direction shown on
the diagram.
- The horizontal position
adjustment range is ±50
mm.
CAUTION
- Mounting should be per-
formed by two people.
WARNING
WARNING
- Be sure to use M6 (1/4 inch) screws or bolts (4 locations)
to fasten the bottom of the wall adapter. Using anything
other than M6 screws (or bolts) could result in the projec-
tor falling and causing injury.
142mm
189mm
Wall adapter
Mount holes
Spacer
Washer