Filter
Top Products
ENG-18
(1)
(2)
(1)
(2)
Cover (A)
Cover (B)
Part where two covers
are fit together
7. Once the adjustments are completed, securely
tighten all the screws that were loosened.
8. Attach the covers to the wall adapter.
Cover (A) and cover (B) have the same shape.
Attaching the covers
(1) Push one of the covers onto the wall adapter.
- The four tabs on the back of the cover fit into the notches in the wall adapter, fixing the cover
in place.
(2) Insert cover (B) from an angle, then rotate it, paying attention to the tabs.
- The four tabs on the back of the cover fit into the notches in the wall adapter, fixing the cover
in place.
Removing the covers
(1) Put a finger into the opening in the top of the cover, then lift slightly upward to unhook the tabs.
(2) Pull diagonally as indicated by the arrows, then move the cover towards you to remove it. Re-
move the other cover using the same procedure.
CAUTION
- Do not pull by force if the tabs on the back of the cover are not unhooked. Doing so could
damage the tabs.