Filter
Top Products
ENG-2
Please heed the following
Symbol
In this “Installation and Adjustment Manual”, to ensure the safe and proper use of the product, pre-
vent harm to yourself and others and damage to property, various symbols are used. The symbols
and meanings are as follows. Please read this manual after ensuring the contents are well under-
stood.
Warning
Improper handling and ignoring this indication may result in
bodily harm such as death, serious injury and so on.
Caution
Improper handling and ignoring this indication may result in
bodily injury and damage to surrounding contents.
Examples of symbols:
Symbol alerts you to cautions (including warnings)
Concrete cautions are specified in figures.
Symbol expresses prohibited actions
Concrete prohibitions are specified in figures.
Symbol expresses compulsory actions.
Concrete instructions are specified in figures.
Warning
• Wheninstallingtheprojectorandadjustingtheprojectionposition,besuretodoso
as explained in this manual. The projector may fall and cause injury if installed and
adjusted improperly.
• Topreventtheprojectorfromfalling,installitinalocationandfastenitsoastoensure
sufficient strength to support the combined weight of the projector, the wall mount
unit and so on for an extended period as well as to withstand earthquakes. Insuffi-
cient strength or fastening may result in the projector falling and causing injury.
Be sure to observe the following precautions:
- Use M6 (1/4 inch) for the wall fixation bolts and screws for the wall adapter.
- Use an outlet for the power source of the projector. Do not directly connect to the
lamp line because this is dangerous.Also, use an accessible outlet so that you can
connect and disconnect the power plug.
- Mounting on a wooden wall
Ensure the load is mounted on a pillar or robust constructional material. If the
strength of the constructional material and so on is insufficient, please reinforce it.
Do not mount on wall finishing material, furring strip and so on.
- Mounting on a concrete wall
Use a commercial anchor bolt M6 (1/4 inch), anchor nuts and similar, which will bear
the load of the projector.