Filter
Top Products
4
To connect the aerial
To prepare the remote control
INSTALLATION
Optimum reception of colour requires a good signal and will generally mean that an outdoor aerial must be used. The
exact type and positioning of the aerial will depend upon your particular area.
Notes
M When using an outdoor aerial, disconnect the
leads of the indoor aerial, if connected, from the
aerial terminal socket.
M It is recommended that the 75-ohm coaxial cable
be used to eliminate interference and noise
which may occur due to radio wave conditions.
M The aerial cable should not be bundled with the
power cord and the like.
Using the ANT(attenuator) switch (See page 6)
When visual interference occurs, set the ANT switch to
ON using a small screwdriver.
Battery installation Tips for remote operation
1
2
Remove the battery cover.
Insert two size AA batteries matching the +
/
-
polarities of the battery to the +
/
- marks inside the
battery compartment.
M When the remote control will not be used for a long
period of time or when the batteries are worn out,
remove the batteries to prevent leakage.
M Do not throw the batteries into a fire. Dispose of
used batteries in the specified manner.
M Do not drop, dampen or disassemble the remote
control.
Effective range
5
S-VIDEO VIDEO (3)L - AUDIO - R
(3) VIDEO 3 input terminals
(S-VIDEO, VIDEO, AUDIO L, R)
Don’t attatch the ‘s-video cable’
& ‘composit video cable’
together.
The picture becomes bad if the
‘s-video cable’ & ‘composit
video cable’ are attatched
together in VIDEO 3 input
terminal.
IDENTIFICATION OF CONTROLS
*
The following describes the name of each part of the TV and remote control.
Main power switch
Infrared sensor POWER indicator
FRONT
SIDE
ON TIMER indicator
ON/OFF POWER TIMER