Filter
Top Products
NILES AUDIO CORPORATION – 1-800-BUY-HIFI – 1-305-238-4373
9
INSTALLATION (continued)
STEP 2 – CONNECTING THE SENSOR CABLE TO THE
CONNECTION HUB
Select four conductors of the supplied CAT-5 wire and strip approximately 1/4" of insulation from
the wire. Insert each wire into the appropriate hole on the removable connector plug (Figure 2),
and snap the locking tab down. To help you, the connector plug is keyed. Insert the smooth side of
-
nector plug into the smooth side of the socket.
To unswitched
AC Outlet
To Niles IR Flasher
Plugged into an switched AC
Outlet. Typically found in back of
a receiver.
Figure 2: