Niles Audio RCA-TT2 Universal Remote User Manual


  Open as PDF
of 28
 
12
INSTALLATION (continued)
STEP 5 – MOUNTING A MICROFLASHER TO A/V COMPONENTS
-
ponents. Locate a place for the remote control that is within arm’s length of the A/V components,
yet cannot directly control them. Place the tabletop sensor no closer than two feet in front of the
remote control (Figure 6).

front panel. Press buttons on the remote control while watching the front panel of the A/V
component. When the component responds repeatedly to the commands, peel off the protective

If the A/V component’s remote sensor is not clearly
-
dow of the A/V component while pushing buttons on
the remote control until you get a response (Figure 7).
Repeat this procedure for each A/V component you
wish to control.
When the A/V component responds repeatedly, peel off


Tabletop Sensor
 previous next