Filter
Top Products
20
FAQ
The coaxial output is normally turned off; therefore, set-top box settings must rst be congured via a TV set equipped with a
SCART connector.
The output can be turned on and TV channels can be set through the technical settings MENU under Televize > RF Frequ
(Television > RF Freq).
Press the STB button on your remote control (you might have forgotten to switch it from TV to DVD back to STB). When pressing
the button, direct the remote control at the set-top box. If the remote control still does not work, check the batteries.
Change the SCART output settings in the technical settings MENU under Televize (Television) so that they correspond with the
settings of your TV set. Check that the TV set is connected to a connector marked TV.
21
technical settings
1. DVB-T can be tuned via the O
2
TV MENU: MOJE SLUŽBY > nastavení >
DVB-T kongurace (
2. You can start searching for channels by pressing the blue button .
This process might take several minutes. You can save your search
results by pressing the
button.
3. DVB-T channels will be saved in your set-top box on channel
positions 300 and above.
4. You can watch DVB-T broadcasts on your set-top box even without
being connected to the modem. Simply press the
button
when you turn on the set-top box.
5. If you watch DVB-T without having the set-top box connected to the
modem, you can run a new channel search via the
button.