Filter
Top Products
26
The ONE FOR ALL Sleeptimer
Your ONE FOR ALL remote comes with an internal Sleeptimer
function for those devices (TV or Satellite) which did not come
standard with this function. To use the ONE FOR ALL
Sleeptimer:
Making your ONE FOR ALL ready for Sleeptimer:
Press the device key (TV or SAT).
Then, press and hold MAGIC until the
red light blinks twice. Press 970. The red
light will blink twice again. It is only
necessary to perform steps 1 and 2 once.
Now to set the timer, continue with the
steps below.
Setting the ONE FOR ALL Sleeptimer:
It is possible to set the timer for 15, 30, 45 or 60 minutes. To
do this, first make sure your TV (or Satellite) is switched on.
Press the Device key (TV or SAT).
Then, Press and release MAGIC then press POWER.
The red light will blink once which
indicates the timer is set for 15 minutes.
To increase the timer, simply press
POWER again (this must be done within
5 seconds). The light will blink twice
indicating the timer is set for 30 minutes
(2x 15). You can press POWER to a
maximum of four times which will set
the timer to 60 minutes.
Once you have set the timer to the desired time, set your ONE
FOR ALL remote down, pointing it at your device. When the
programmed amount of time has elapsed, the ONE FOR ALL
will send the command for Power, hence turning off your
device.
Advanced Features
Important notes:
- The red light on the ONE FOR ALL will blink every 15 seconds
indicating that the remote is in Sleeptimer mode.
- To deactivate the Sleeptimer, simply press any key on the ONE
FOR ALL remote.
- Also, it is only necessary to follow steps 1 and 2 above one time.
For subsequent use of the Sleeptimer, simply begin with “Setting
the Sleeptimer”.
- To switch the ONE FOR ALL back to Device Sleeptimer (page 25),
repeat steps 1-2 above. The red light will blink 4 times.
- Remember, when using the ONE FOR ALL Sleeptimer, you must
set the remote so it is pointing to your device.
(:15)
(:30)
(:45)
(:60)
1
2
or